EIGRP named configuration

16 Mar

Daniels networking blog

You might think that EIGRP being around for so long is not getting any attention from
Cisco, not true. EIGRP is still being developed and in later releases you can run what
is called named configuration. Doing this you can put all EIGRP config under one named
instance, even v6 which is different from the old syntax. If you are on Twitter you should
follow Donnie Savage @diivious. He works for Cisco and is usually present at Cisco Live
presenting on the development of EIGRP.

We start out with the following topology.

EIGRP_named_1

So we start out by defining our instance and calling it corp

R2#conf t
Enter configuration commands, one per line.  End with CNTL/Z.
R2(config)#router eigrp corp

From there we have the following options:

 R2(config-router)#? Router configuration commands: address-family Enter Address Family command mode default Set a command to its defaults exit Exit from routing protocol configuration mode no…

View original post 740 more words

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: